Interesting. This seems like a much higher power device. What are the actual power requirements? So far my probe has been powered from the USB port on the router, and I’m concerned that this may make the installation of future probes more difficult.

On Thu, Feb 7, 2019 at 2:59 PM Robert Kisteleki <robert@ripe.net> wrote:

On 2019-02-07 13:50, Micha Bailey wrote:
> Any updates regarding v4, in terms of what the hardware is etc.?

Hello,

We use the NanoPi NEO Plus2 as the v4 probe:
https://www.friendlyarm.com/index.php?route=product/product&product_id=196

The firmware on it is essentially the same as on the older, v3 probes.

Regards,
Robert